Top » Catalog » Kits » M-1.0t Kits » IBP-1

$8.50

Idle Bias Pivot
[IBP-1]

Want a clean, neat solution to installing your Idle bias pivot circuit, also referred to as the Fulcrum Bias Pivot in documentation available from the public domain?

Well, here is a small PCB that provides a firm base for adding those extra parts to your amp. No more "floating" off the interconnect cable to transistor Q112(1) on that small PCB hanging next to the Heat-Sink. Depending on your school of thought, this PCB can be installed at either end of the three wire cable with the parts supplied, just be sure that the three holes with the White Silkscreen Box around them is the side connecting to the Main Amp PCB. The Idle Bias Pivot PCB size is approx. .425 x .725 inches.

This PCB kit contains ALL the parts you need for the Idle Bias circuit add-on for the M-0.5t or M-1.0t amplifiers.

(Assembly required) Included:

• 2 IBP-1 PCBs
• 2 2SA1015 transistors
• 2 1.3K Ohm resistors
• 2 3.0K Ohm resistors
• 2 1K Ohm Trim Pot
• 2 Right Angle, Gold, 3-pin connectors
• 1 Instruction sheet (just in case)

Instructions written for a Main PCB installation.

NOTE: This Kit can also be installed on an Original "Stock" Carver M-1.0t to aid with lowering the Over-All heat-sink temperatures by up to 10 degrees!

Reviews
Categories
Aji Seeds (3)
Hardware-> (10)
Belts (14)
Manuals-> (273)
Kits-> (10)
  M-1.0t Kits (8)
  V3I Kits (2)
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
We Accept
0 items
Manufacturer Info
Kalltronics
Other products
Share Product
Share via E-Mail Share on Facebook
Share on Twitter
Currencies
osCommerce